2013/03/01

Process Selection And Design

Running Head: PROCESS SELECTION AND DESIGN

Process pickaxe and Design
University of Phoenix
OPS/571 Operations Management
Alvaro Carreras
July 6, 2009

Process Selection and Design
Introduction
A change performed on a daily basis during the 9 to 10 months of the check year is capricious to play. This process includes driving to a babe’s school and dropping him off on clip before the tardy bell rings. The process then continues to driving to utilisation with hope of devising it on time to suit good parking. The later one arrives at work the slash parking female genital organ get since the capacity and staff consists of round 200. Even though the parking lot is specifically for faculty and staff some students will also park there. It would be good if this process could be done in less(prenominal) time to ensure that a good parking sleep together is located. For this reason a process design will be used in which factors affecting the design will be noted, metrics for measuring the process will be place and a flowchart for the process will be created.
Factors bear upon the Design
Several factors affect the process design of driving to work. The head start factor affecting the process is the time the drive to work starts.

Order your essay at Orderessay and get a 100% original and high-quality custom paper within the required time frame.

If the drive begins between 7:00 and 7:05 there’s a good chance for good parking barely if the drive begins later the traffic flow is greater making the drive take longer. Another affecting factor is an convergence needed to be crossed over which doesn’t nurture traffic lights and has a speed limit of 60 mph. At times this intersection is so busy it takes a succession to cross through it. The final affecting factor is the two school zones along the route as well as the school zone to dropping off the child. These school zones can slow the process down if the cross guard has to contain the flow of traffic to let students go by.
Metrics for Measurement
devil metrics can be used to measure this process of driving to work. The first metric is the efficiency of getting to work on...If you want to get a full essay, order it on our website: Orderessay



If you want to get a full essay, wisit our page: write my essay .

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.