2013/02/26

Cfd Modeling Of An Infinite Cylinder

Bermet Kerim kyzy
Student ID: 201026928
Tutor: James Jackson
Assignment 1
Word itemise: 986
CFD Modeling of an Infinite Cylinder.
Computational gas dynamics (CFD) is the dissembling of fluids, heat transfer etc., using modeling and numerical methods (discretization methods, solvers, etc.) (Adair, 2011). bugger off of the present essay is to determine proper conditions and argumentations in graze to model the attend through an infinite cylinder on an enclosed topographic point.

Figure1

The first parameter to be determined is the graphic symbol of the flow, which can be either 2D or 3D. It is set aside to use 2D flow, because the cylinder is of infinite length and the flow is the same along the length of the cylinder, no edge exercise etc. So, evaluation of the flow on 2D space will fully describe the behavior of the fluid.
Next parameter of particular interest is the type of flow (steady or unsteady). This trait of flow is determined by Reynolds number, which shows the ratio of inertial forces that suffer to the change of motion to viscous forces that resists to the tensile or rob stresses.

Order your essay at Orderessay and get a 100% original and high-quality custom paper within the required time frame.

Reynolds number can be evaluated using the following design:
Re=Du/?,
where Re is the Reynolds number, D diameter of the pipe (cylinder), u- fluid velocity, ? kinematic viscosity of the fluid, constant parameter, which at 20 oC is equal to ?=15,11x10-6 m2/s (Engineering Toolbox, 2011).
Calculations show Reynolds number to be equal to Re=26,5x103.
unfaltering flow occurs at low Reynolds numbers (Re<2000), while at Re>4000 we have turbulent flow, i.e. it is unsteady with eddies, vortices etc. As the value of Reynolds number is more than 4000, the flow is turbulent or unsteady. (NASA, 2011).
Boundary conditions should be defined to describe the motion of fluid. We should get the boundaries at the top and at the edge of the cylinder. In addition, we go into no-slip or free-slip on walls, set the velocity at the inhalation and outlet pressure, while boundaries along z-direction...If you want to get a full essay, order it on our website: Orderessay



If you want to get a full essay, wisit our page: write my essay .

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.